a. To open the lens housing door, grasp the top corner of the plastic door and pull it
away from the hood.
b. Open the package of protective lens cartridges.
c. Insert the lens cartridge into the lens housing. The cartridge can be installed so
that the pull-tabs are either at the top or the bottom of the lens housing.
NOTE:
Be sure the 2 pull-tabs are not caught in the lens door opening.
d. Close the lens housing door to force the lens cartridge into place. Pull on the door without flexing the latch to be
sure the door is secured.
4. If a filter cartridge is to be used, see
8.2 Replacing the Filter Cartridge
for instructions.
NOTE:
The filter cartridge is not approved for use on the combination Duo-Flo type respirator.
5. Disconnect the socket assembly from the valve-connector body and thread the
socket assembly on the air-supply hose.
6. Connect the opposite end of the air-supply hose to a respirable air source.
13
Abrasi-Blast Respirator
US
3 Assembling the Respirator
