User manual
500GD
MRU GmbH, D-74172 Neckarsulm
7 / 52
2
Introduction
•
Read and observe the safety manual supplied separately.
•
This user manual enables you to operate the analyser safely.
•
Read this user manual carefully.
•
Make yourself familiar with the analyser, before using it.
•
The analyser may only be used by skilled personnel and may only be
used for its intended purpose.
•
Pay special attention to the security and warning precautions, in
order to prevent injuries and product damages.
•
MRU can’t be held responsible for damages or injuries,
by not
following the instructions in this manual.
•
Always keep this user manual near you, when working with the
analyser, to be able to read instructions as needed.
•
Ensure to hand over all documents to when handing the analyser
over to other.
2.1.
Intended use
The analyser is a multidetector. Due to interchangeable sensors, the
analyser can be used for a wide range of applications:
•
Usable with interchangeable sensor RM400 for leak detection on ex-
haust pipes.
•
Usable with interchangeable sensor HC400, HC401 and HC402 for
leak detection on gas lines in non-explosive environments.
•
Usable with interchangeable sensor RF400 for leak detection on
refrigeration systems.
•
Usable with interchangeable sensor HM400 to measure environmen-
tal parameters (air pressure, humidity, air temperature and dew
point).
•
Usable with interchangeable sensor CO400 for monitoring the CO-
concentration in the ambient air.
•
Usable with interchangeable sensor CD400 for monitoring the CO
2
-
concentration in the ambient air.
Note that all interchangeable sensors are developed for indoor use only.
►
Do not use the interchangeable sensors outdoor.
The analyser records and stores measured values. The measured
values can be exported by QR code.
The analyser was manufactured according to relevant standards and
regulations. The analyser must be used according to the instructions
for the intended used.
