MrCool U-match MDUI18024, Service Manual

Page: 83 / 120

MRCOOL Universal Service Manual
80
Removal of condenser
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step Picture Work instruction
5. Take out the condenser.

Loosen the securing screws
of condenser support. Take off
the plate type heat exchanger
and the support as a whole.
6. Install the new condenser.
Welding interface

Secure the screws of
condenser and support. Then
fix them together on the
chassis.

Install the condenser by
referring to the positions of
entering and leaving pipes.
Weld the connection pipes.

Nitrogen welding: the
pressure of nitrogen is
0.5±0.1kgf/ c ㎡ (relative
pressure).
Note: When welding the
pipes, do not let the flame
burn the other components.
7. Secure the electric box
and arrange the wires
according to the
requirement.

Put the electric box in place
and tighten up the screws of
electric box.

Arrange and secure the wires
as original.