Installation Procedures
3
Page 5
How To Install
mrcool.com
(1)
Tools Required:
•Phillips (cross-tip) screw driver
•Adjustable wrench
•Scissors
(2)
Please review the Packing List previously mentioned and ensure all items are included in the packaging.
(3)
Installation Position Required:
•Close to 220V /11 OV socket
•Close to drain outlet, please note that the position of drain pipes should be at least 20cm lower than water
pan, please refer to (7) of 3.
(4)
Connect the silicon tube to the drain of the water pan or a bucket.
(5)
Connect power supply and power on, the machine will start producing water. During this period, the switch for
heating should be off.
•After the machine completes water production (White light around the big button in the middle), cut off the
power supply. Connect the silicon tube to "drain of hot water tank" and the other end to drain of the house or
a bucket to drain out all the water in the tank.
•Power on again and make the machine to produce water and then drain out all the water in the tank after
water production is completed. Repeat this process for 2 to 3 times to flush the machine. During this process,
pay attention to all connections to see if there is any leakage.
•After flushing, take off the silicon tube and pack it up. Block the "drain of hot water tank".