13
connect the fan line with the wire harness in the rear cabinet, the connection is completed. Plug the
power cord, close the air switch, turn the emergency switch in the direction of the arrow, press the
power button, press the fan button to check whether the fan runs properly.If not, please refer to 3.1
to conduct troubleshooting. Press the lighting button to check whether the LED fluorescent light is
lit, if not, please refer to 3.1 to conduct troubleshooting. If there is no trouble, please conduct the
next installation step.
Note: Before installation, please turn of the power, so as not to get an electric shock, cause an
accident during the installation process, accidents.
（
5
）
Installation of Homogeneous Film
Figure 11
Firstly remove the UV lamp holder from the card slot (no need to disconnect the UV lamp). Take
the homogeneous film, and make it face downwards, and fasten it with 12 sets of stainless steel
hexagonal bolts M4 * 30 +12 groups of flat gaskets 4, spring gaskets 4. After the installation of the
homogeneous film is completed, install the UV lamp holder into the card slot. After the lamp is
inserted into the lamp holder, the lamp is rotated clockwise (or counterclockwise) by 90 degrees.
The installation is completed and the power test can be performed. After the installation, conduct the
next installation step.
（
6
）
Installation of Anti-static Curtain
Figure 12
UV lamp
Homogeneous Film
Outer row cover
panel
Keel
Anti-static curtain
