MRC AUDIO EQ
Limit
10
The content of the box is:
EQ
Limit
MS1 Microphone
Remote display DD1 (optional)
USB cable
Power feed cable
Backplane cover TP2
Microphone cable CM10
NOTICE: The graphics included represent the equipment with all its accessories. Some may
be optional. If you need an accessory, include it in your order.
5.1.- Connections
Input and output connexions are made by means of XLR-3 connectors. The connection
pin out follows the international standard: Pin 1 is signal ground, Pin 2 (+) is non-inverted
and pin 3 (-) is inverted.
Please be sure to follow the same scheme in both channels to
avoid phase cancellation problems.
Connect input and output audio signals (
13
and
14
) in such a way that the limiter is
connected just before the crossover or power amplifiers if there is no crossover.
Either balanced or unbalanced lines are used, be sure to follow the same pin out at both
channels to avoid phase cancellations.
Connect the microphone(s) to the
MIC1
and
MIC2
(optional) (
15
). Position the
microphone in a centred position with respect to the speakers in order to measure both
audio channels. Try to position the microphone as near as possible to where the
authorities would control the sound level from music, not the audience.
Optionally connect the remote display by means of its cable to the connector
DISPLAY
(7)
. The remote display cable is 5 meters long.
Finally, connect the mains cable supplied with the unit to the mains input and the unit
will switch on. Do always connect the earth connection for your personal security.
Test for correct sound. If the remote display is installed verify that the metering varies
according to the sound level in the house. If display
Und
(35dB or less) maybe the cable
is connected in wrong way and sounds mute.
