MRA BMW R1200RS, Mounting Instructions, Page: 3 / 8

3
GB
MOUNTING INSTRUCTIONS
BMW R1200RS 2015-
Thank you for buying a MRA Windshield.
Read this manual carefully and check the parts list for completeness before you begin. We recommend
that you have your screen fitted by an authorised workshop.
Number Article Article No.. Required tools
1 MRA screen --- Allen key, 3 mm
Torx TX25 screwdriver
2 Spacers, 6 mm 11038
2 Spacers, 10 mm 10633
2 Oval head screws, M5 x 16 mm 10554
2 Oval head screws, M5 x 20 mm 10673
4 O-rings, 4.5 x 1.5 mm 10992
4 Plastic washers, 12 x 5 mm 10635
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Dismantle the original screen.
3. Insert the M5 x 20 mm oval-head screws with the plastic washers into the upper holes
on your MRA screen; then place the 10 mm spacers and O-rings (as mounting aids)
onto the screws from the inside (P1).
4. Insert the M5 x 16 mm oval-head screws with the plastic washers into the lower holes
on your MRA screen; then place the 6 mm spacers and O-rings (as mounting aids)
onto the screws from the inside (P1).
5. Position the MRA screen and tighten the screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
spirits to clean the screen as they will damage it.
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de