MR MSENSE VAM, Operating Instructions Manual

Page: 43 / 174

6 Mounting
Maschinenfabrik Reinhausen GmbH 2021 43 6796573/02 EN MSENSE
®
VAM
6 Mounting
This chapter describes how to correctly mount and connect the device. Note
the connection diagrams provided.
DANGER
Electric shock!
Risk of fatal injury due to electrical voltage. Always observe the following
safety regulations when working in or on electrical equipment.
► Disconnect the equipment.
► Lock the equipment to prevent an unintentional restart.
► Make sure all poles are de-energized.
► Ground and short-circuit.
► Cover or cordon off adjacent energized parts.
NOTICE Damage to the device!
Electrostatic discharge may cause damage to the device.
► Take precautionary measures to prevent the build-up of electrostatic
charges on work surfaces and personnel.
Installing the MSENSE® VAM monitoring system includes the following
steps, which are described in the following sections:
1. Depending on the product version selected, install the cap rail modules in
the customer control cabinet or in the control cabinet on the transformer.
You will find the appropriate description in the "Cap rail module assembly/
control cabinet" [
► Section 6.1, Page 43] section.
2. Mounting the vibration sensor [ ► Section 6.2, Page 50]
3. Connecting the assemblies [ ► Section 6.3, Page 51]
– Connecting the vibration sensor to the control cabinet
– Connecting the motor-drive unit controller to the monitoring system
– Connecting the temperature sensor
– Connecting additional leads
– Connecting the power supply
After completing the installation, check the functionality [ ► Section 6.4, Page
66].
6.1 Installing the Cap rail modules / control cabinet
6.1.1 Installing the cap rail modules
With the MSENSE® VAM product version as an integration solution in the
customer control cabinet, the cap rail modules must be installed in a suitable
control cabinet, taking the EMC standards into consideration. This section
does not apply for other product versions.