mr
.
steam
®
Controls
__________________________________________________________________
7
STEP 2
Peel the double stick adhesive off the back of the
iSteam control (2a). Apply a bead of silicone around
the rear of the iSteam control to create a moisture seal
(2b). Carefully feed the cables into the rough-in box
and secure the control to the wall. Care must be taken
to not pinch the cables. Ensure the control is level.
IMPORTANT NOTE:
The iSteam control display
reads in one direction only. The control must be in-
stalled with the arrow on the Peel-Off screen protector
facing up. If the Peel-Off screen protector has been re-
moved see the drawing in Step 2b for the proper ori-
entation.
NOTE:
The silicone supplied by Mr. Steam
®
can be
used to meet a variety of sealing and gasketing. It
cures to silicone rubber and adheres to glass, wood,
metal, porcelain, ceramic tile, painted surfaces, many
plastics and rubber. Surfaces must be clean and dry.
Apply thin layer of product. Fit together and support if
necessary. Allow excess material to cure, then trim
with a sharp blade. Sealant “skins” in 5 minutes, dries
to touch in 1 hour. Fully cures and bonds in 24 hrs.
IMPORTANT NOTE:
Do not apply excessive amounts
of silicone. Do not apply silicone to any other parts of
the control including the adhesive gasket. Insure the
mounting surface is clean and dry as required for
good adhesion. Hold the control with the arrow on the
screen protector facing up and press the control
against the wall until the adhesive sticks and holds
firmly. Control may have to be supported or secured
until the silicone has cured for 24 hours.
8:19
AM
ACCE
SSORIES
SETTINGS
STA
RT
8:19
AM
ACCE
SSORIES
SETTINGS
STA
T
T R
T
Installation Instructions for iSteam
®
(cont.)
2b
2c
2a
This
End
Up
Before use, remove
and discard the peel-
off screen protector.
This
End
Up
