21
Installer and Home Owner Section
Linear Steam Head
7
®
®
NOTE:
Drawings are for illustrative purposes only.
Consult with qualified designer, architect or contractor for steam room construction.
Model 104480
Diverter
The Linear SteamHead is supplied with an optional steam diverter. The steam diverter is used to reduce
the steam emission zone as required to avoid contact between a steam bather and direct steam
emissions.
Supplied steam diverter does not have decorative finish. Steam diverters with decorative finish are available
for purchase.
Always use the diverter if any steam bather may come into contact with direct steam
emissions. Contact MrSteam if a replacement diverter is required. Failure to use a diverter to reduce the
steam emission zone as required to avoid contact between a steam bather and direct steam emissions may
cause personal injury.
Because direct steam is very hot, the diverter will be hot during the steam session, and will
remain hot for a period of time after steam session. Never install, remove or adjust a diverter when the steam
head is hot or if steam generator is turned on. Installing, removing or adjusting the diverter when the steam
head is hot or if the steam generator is turned on may cause a burn hazard and personal injury.
The optional diverter reduces the steam emission zone by redirecting steam up the wall above
the steam head ( see page 6 ). Installation of the diverter may result in the following:
• Changes to the steam distribution in the room
• Increase of the temperature of the wall and devices above the steam head
• Surface condensation patterns on the walls and ceiling
Always test the diverter to insure proper safety, installation and comfort.
STEP 1.
Securely press the two rubber extensions into the opening of Linear Steam Head and push in firmly
until the diverter is securely in place. (see Fig. 7).
Figure 7
Diverter
Rubber
Extensions
Rubber
Extensions
