Mr Safe GPS Bike Light, Full Manual

Page: 7 / 19

GB
1. Content of the packaging
- Mr. Safe GPS Bikelight
- USB-charging cable
- Screwdriver and screws
- Mounting clamp
- Quick Start Guide
2. Parts & buttons
A: LED indication Red LED: charging
Green LED: scanning for Phone signal
Blue LED: scanning for GPS signal
B: Simcard-slot
C: USB-slot
D: Multifunction-button
3. Ready to start!
Congratulations with the purchase of your mr. Safe GPS Bikelight.
We strongly recommend you to charge the product completely before using it for
the first time.
Connect the included USB-charging cable with the GPS Bikelight on one end and a
USB-power source (laptop, power bank,…) to charge the product. The USB slot can
be found at the bottom of the product, next to the Multifunction-button. The LED
indicator will light up RED when the product is being charged. When the red LED is
off, the GPS Bikelight is completely charged.
After configuring the SIM card, the product will send a text message when the
battery is almost empty:
Notice: Low battery alert.
4. Turning on the device
The mr. Safe GPS Bikelight is equipped with a multifunction-button on the bottom.
Press the multifunction-button once to turn on the continuous LED light,
Press twice to enable the pulsating LED light,
Press three times to turn off the device. Two seconds after pushing, the LED light will
turn off.
5. Installation SIM card and Mounting the device.
The mr. Safe GPS Bikelight only works on SIM cards that are suitable for calling and
internet. Make sure the GPRS function and Caller-ID function are enabled and that
your SIM card is pin code free. (After unlocking your SIM card in a smartphone, you
can enable the pin code requesting)
Remove the screws and the cover on the left side of the Bikelight and insert the SIM
card in the foreseen slot, according to the sticker.
7