Mr.Paldu Horizontalspalter 550, Operating Instructions Manual

Page: 9 / 40

Page 7
Operating the log splitter
Set-up
Position machine on level and firm
ground. Position board under feet if
ground is too soft.
Caution!
Only operate machine if set
up securely!
Start-up
Note:
In temperatures below 0°C, leave
machine to idle for approx. 5 minutes
without operating the control lever until
the hydraulic system has reached its
operating temperature.
230 V motor models

Connect machine to power supply.
• Supply voltage 230 V (50 Hz)
• Use 16 A fuse)
• The supply cable must have a
minimum diameter of 2.5 mm
2
.
400 V motor models

Connect machine to power supply.
• Supply voltage 400 V (50 Hz)
Caution!
The mains supply must not
fall below 340 V in order to avoid
damages to the switch.
• Use 16 A fuse)
• The supply cable must have a
minimum diameter of 2.5 mm
2
.

Observe the direction of rotation of
the electrical motor (see arrow on
motor).
In case of wrong rotation direction:
• The switch plug contains a phase
reverser for changing the rotation
direction of the motor (push down
plate in plug with screwdriver and
turn by 180°).
Fig. 3 - Phase reverser
Caution!
If the plugging connections
are too tight the CEE-plug can be torn
out of the switch case.