TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Indicator lights
are on but
display is not
on.
Blown fuse/ No power.
Replace fuse/ Turn power on.
“Ice Full”
indicator is on.
Ice basket is full.
Remove ice from ice basket.
The
compressor
works
abnormally
with a buzzing
noise
The voltage is lower than
recommended.
Stop the ice maker and do not
restart until the voltage is normal.
“Add Water”
indicator light
is on.
Water is low.
Press the OFF button, fill with water,
wait for 3 minutes and press ON to
restart. When the water has reached
the fill line the ice maker will restart
automatically.
The pump is full of air.
Unplug the silicon stopper and let
several drops of water run out.
The ice made is
too large and
cubes are
sticking
together.
Ice from previous cycles were left in
the water tray.
Stop the unit right away. Restart the
unit after the ice in water tray melts
down.
The evaporator rods are too low.
Shift the evaporator rods up a little.
Water temperature in inner tank is too
low.
Change the water in the reservoir.
-
.
“Add Water” &
“Ice Full”
indicators both
light up.
Water tray/Ice Case Panel are blocked
by ice cubes.
Clear the ice cubes under the ice
case panel, pull out the power plug
from wall outlet and then plug back
in. Press the “ON/OFF” button, allow
a few minutes for the machine to
restart automatically.
8