Mr. Coffee EHX33 Series, User Manual

Page: 6 / 30

carafe lid, and filter basket.
Your coffeemaker is now ready to use. Enjoy it!
SETTING THE CLOCK AND DELAY BREW
TIME
To Set the Clock:
1. Plug the power cord into a standard
electrical outlet. The clock will flash on
the control panel to indicate that the
time has not been set yet.
2. Press and hold the HOUR and MINUTE
buttons until you reach the current time.
The AM or PM indicator will light at the
bottom of the display (Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting the
clock will cause the clock to start keeping
time from 12:00 a.m. You must set the clock if
you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode,
simply press the SET DELAY button (Figure
3) and, while the DELAY BREW light is
flashing, set the brew time by pressing the
HOUR and MINUTE buttons. The AM or PM
indicator will light at the left of the clock
display. (Figure 4)
Within a few seconds the display will
change to the current time.
The Delay Brew Time is now set!
NOTE:
To activate the DELAY BREW cycle,
see the “Brewing Coffee Later” section.
10 11
• Programmable Controls:
–
Clock
– The clock serves as a handy kitchen clock
and allows you to set the Delay Brew feature and
functions as the FRESH BREW™ TIMER feature.
– Fresh Brew™ Timer feature – Lets you know how
long your coffee has been waiting for you.
– Delay Brew – Would you like to wake up to a
fresh pot of coffee? The timer allows you to
preset when you would like the coffeemaker to
automatically begin brewing your coffee, up to 24
hours in advance.
NOTE:
If you have selected any of the operating
functions, the coffeemaker will act upon the last
operation selected if the power is restored within 10
seconds after a power outage.
CLEAN YOUR COFFEEMAKER BEFORE USING THE
FIRST TIME
Make sure your first cup of coffee is as good as can be
by cleaning your MR. COFFEE
®
Coffeemaker before its
first use. Just follow these simple steps:
1. Wash the carafe, carafe lid and the filter basket in
a mixture of mild detergent and water. Rinse each
thoroughly (please refer to the parts diagram listed
above).
2. Replace all the parts and close the lid. Then, run a
brew cycle with water only, without adding coffee
and coffee filter.
3. When brewing is complete,
turn your coffeemaker off,
discard the water in the
carafe and rinse the carafe,
Figure 1
Figure 2
Figure 3
Figure 4