5.1 One click - Autosleep Enable/Disable
Initially the LED will be dim to indicate Autosleep will be active. A click will brighten the LED to indicate
Autosleep will be inactive. Each click will cycle from active to inactive. When you are happy with the choice,
wait 2.5 seconds and the LED will flash once to indicate the selection has been made and the light will turn off.
5.2 Two clicks - Configuration Selection
Initially the LED will light up bright to indicate Configuration Mode 0 will be active. A click will light the LED
up dim to indicate Configuration Mode 1 will be active. Each click will cycle the Configuration Modes. When
you have happy with the choice wait and after 2.5 seconds the LED will flash once to indicate the selection has
been made and the light will then turn off.
5.3 Three clicks - Force Mode Enable/Adjust/Disable
Note: Force Mode is only applicable to Configuration Mode 1.
Initially the LED will dim to indicate Force Level 1 (dimmest) will be active. Each click will cycle to the next
Force setting. The sequence is:
· Force Level 1 (LED dim)
· Force Level 2 (LED med/low)
· Force Level 3 (LED medium)
· Force Level 4 (LED med/high)
· Force Level 5 (LED brightest)
· Force Disabled (LED is off)
The sequence will cycle through all 6 choices. The LED brightness matches the 5 operating levels of
Configuration Mode 1. When you are happy with the choice, wait 2.5 seconds. The LED will flash once to
indicate the selection has been made and the light will then turn off.
5.4 Menu Selection Complete
Once the above menu procedure is complete and the light turns off the new menu selection is immediately
active. The light is ready to be used.
Thanks Again
for buying this light!
Regards and Aloha,
MR Bulk
