QP3TS TRASH PUMP • OPERATION MANUAL — REV. #0 (03/02/20) — PAGE 23
ENGINE AIR CLEANER
1. Remove the air cleaner cover and foam filter element
as shown in Figure 14.
2. Clean foam element in warm, soapy water or non-
flammable solvent. Rinse and dry thoroughly. Dip the
element in clean engine oil and completely squeeze
out the excess oil from the element before installing.
Figure 14. Engine Air Cleaner
3. Clean foam element (Figure 15) in warm, soapy water
or non-flammable solvent. Rinse and dry thoroughly.
4. Next, dip the element in clean engine oil and completely
squeeze out the excess oil from the element before
installing.
Figure 15. Cleaning Foam Element
DANGER
DO NOT
use gasoline as a cleaning
solvent, the possibility exists of fire or
explosion which can cause damage to
the equipment and severe bodily harm or
even
DEATH
!
SOLVENT
ENGINE OIL
FOAM
ELEMENT
SQUEEZE
THOROUGHLY
DAILY
1. Thoroughly remove dirt and oil from the engine and
control area. Clean or replace the air cleaner elements
as necessary. Check and retighten all fasteners as
necessary. Check the spring box and bellows for oil
leaks. Repair or replace as needed.
ENGINE OIL
1. Drain the engine oil when the oil is
warm
as shown
in Figure 13.
2. Remove the oil drain bolt and sealing washer and allow
the oil to drain into a suitable container.
3. Replace engine oil with recommended type oil as listed
in Table 5. Engine oil capacity is 1.16 quarts (1.1 liters).
DO NOT
over fill.
4. Install drain bolt with sealing washer and tighten
securely.
Figure 13. Engine Oil (Draining)
RUBBER
GROMMET
SEALING
WASHER
DRAIN BOLT
OIL FILLER
DIPSTICK
MAINTENANCE (ENGINE)
To
order
go
to
Discount-Equipment.com
