35
34
•
If another person intends to use the device
permanently, all data from the previous
user be erased as explained in this manual.
•
In case another user has already used
the monitor, we recommend disinfecting
the measuring tube as explained in this
manual. In this case we also recommend
that each user uses a new mouthpiece.
Extra mouthpieces can be ordered through
your distributor.
1. Press the ON/OFF button to turn the device
on. At first, the last result of the memory is
shown («0» if there are not yet data) and
then the device indicates «READY» for a
measurement by two short beeps and
blinking arrows.
2. You can perform the measurement while
standing or sitting upright. For better
comparison of your data you should
always perform the measurement in
a similar position.
3. Hold the monitor with both
hands on the two rubber areas
(compartments).
4. Inhale completely and hold
your breath for a moment.
11. The current minutes can now be entered
by pressing the arrow button. (Example:
pressing 9 times on the left arrow button
moves to 50 for 09:50 o'clock).
12. Press the time switch again to confirm
all settings. Date and time are now
stored, the clock starts running and the
monitor switches to «ready» condition
which enable your first measurement.
13. Close the data compartment.
•
Please note:
If you hold down the arrow key for
more than 2 seconds it speeds up.
•
Date/time can also be set easily from
computer when you run the Analyser
Software.
4. CARRYING OUT A MEASUREMENT
•
MicroDrop
®
pf 900
should only be used
by one person. With different users the
automatically stored data is useless,
because they cannot be assigned to an
individual person.
•
If time/date is not set, data is
not stored-«E1» is shown when
switching off.
MicroDrop®pf 900_GBA 23.07.2003 16:38 Uhr Seite 34
