
4.
Fill the iron water tank
❽
from the measuring cup up to the MAX level. Check the max level
in the tank by putting the iron straight up.
CAUTION! Do not overfill the water tank above the MAX level. Always use fresh demineralised/distilled water
for best ironing performance. Never use chemically decalcified water or any other liquids.
5.
Close the water fill lid
⓫
.
USING THE APPLIANCE
TEMPERATURE SETTING
1.
Plug the power cord
❻
to a PE mains outlet.
2.
Put the iron standing up and set the required ironing temperature by turning the tempera-
ture control knob
❺
to the desired position. The indicator
❼
will turn on.
TEMP KNOB POSITION
THERMOSTAT ADJUSTMENT
TEXTILE TYPE
•
Low temperature
Synthetic fibres
• •
Moderate temperature
Silk / wool
• • • / M a x
High temperature
Cotton / linen
CAUTION! Check the required ironing temperature of your textile product by referring to its information tab.
If you are unsure what fabric type the product to be ironed is, find the correct temperature setting by ironing
the part of the product that will be concealed when in use/worn. Start from the lowest temperature setting
and increase it gradually. Silk, cotton and synthetics: to prevent glossy spots from heat, iron these materials
inside out and covered with another thin fabric. Do not use the spray jet to avoid stains while ironing. Velvet
and similar materials must be ironed in one direction only. Do not hold the iron in one spot, make full passes.
Iron synthetics and silk inside out and without steam.
CAUTION! Always start ironing with the products that require the lowest temperature setting.
3.
When the indicator
❼
turns off, wait a few seconds and start ironing. The indicator
❼
turns on
and off during ironing. When the indicator is off, the iron has reached the preset tempera ture
and you may iron.
4.
If the iron is set to high temperature from the start and then switched to a lower one, contin ue
ironing when the indicator
❼
is on again. This will protect the textile from burn damage.
NOTE! The iron is equipped with the Auto „SHUT OFF” ( „FIRE FIGHTER” - electronic safety system) function. This
is an electronic, safe switching of when the iron is not used for a longer period of time. This safety funcis active
when the iron is positioned in the horizontal or vertical position.
STEAM IRONING
1.
Make sure that the water tank
❽
has enough water.
2.
Set the temperature to steam ironing (the steam ironing temperature range is shown with
at the temperature control dial).
3.
Set the required steam output with the steam control slider
❶
:
- Far right: continuous high steam output
13
EN
Summary of Contents for MZE-21/NS
Page 30: ...N O T E S 30 ...
Page 31: ......