MPM MOD-22, User Manual

Page: 17 / 60

17
EN
A. Engine’s set. This section includes an engine, a switch and operating elements. Upper
part of this section constitutes HEPA filter used to filter out dust and other small parts from
the air that is blown out. Under a foam filter there is a big, plastic float which, as the container
fills up, raises and cuts off vacuum at the same time informing about a necessity to empty the
container.
A1 – Pump switch
A2 – Hoover switch
A3 – Connector for a washing liquid hose
A4 – HEPA filter socket
A5 – HEPA filter
A6 – Cover of HEPA filter case
A7 – Float chamber
A8 – Foam filter
A9 - Gniazdo do parkowania
A10 - Uchwyt do przenoszenia
B. Container. The container section is a middle part of a vacuum cleaner, used as a container
to collect dust and dirty water. This section is attached to engine’s set with clamps. A contain-
er for a shampoo and clean water (washing liquid) is located under the water filter container.
B1 – Container
B2 – Water filter element
B3 – Water filter sponge
B4 – Water filter tube
B5 – Rubber gasket
B6 – Clamps
B7 – Locks sockets
B8 – Sucking inlet
C. Washing liquid container. Washing liquid container has a shampoo and clean water.
When the pump works, shampoo and water are taken from the tank. Liquid going from the
container through a hose is sprayed. Liquid container is situated between a water filter con-
tainer and a base with wheels.
C1 – Washing liquid container
C2 – Short washing hose
C3 – Short washing hose connector
C4 – Indicator of water level
D. A base with wheels.
D1 – Base
D2 – Wheels
D3 – Lock
E. Hose. This section includes a sucking hose with a handle and sucking tubes. Sucking at-
tachments connected with container’s set through putting the hose into sucking inlet. Suck-
ing tubes are jointed with each other and then connected to a handle. The handle has wash-
ing liquid feeder and sucking power regulation. The hose can be put on engine’s set with the
use of hanger.
E1 – Element fixing a sucking hose