MPM MBL-15M, User Manual, Page: 12 / 36

12
EN
USING CUP BLENDER
NOTE! Do not put or remove the blender jug while the appliance is running.
1.
Place the blender housing (2) on a dry, hard and even surface.
2.
After checking whether all parts of the jug are properly installed, place the jug (2) in such a
way that the

symbol on the base faces the

symbol on the blender housing (fig. 1).
3.
Cut the products into smaller parts to make mixing easier. Put ingredients into the jug only
when the motor is stopped.
NOTE! Do not fill the jug above the mark of 1000ml (3).
4.
Place the lid with the hole plug.
5.
Plug the appliance into the power supply socket.
6.
Turn it on with the knob (1), choosing one of two operating modes.
7.
During mixing always hold the lid. If you need to add ingredients when the cup blender is
running, remove the hole plug from the lid (8) and feed the ingredients through the hole,
and then replace the plug (8).
8.
When mixing is complete stop the appliance by turning the knob (1) to the <<0>> position
and unplug the power supply plug from the socket.
ATTENTION! Before pouring out the content of the jug wait until the knife stops rotating!
USING QUICK&EASY BLENDER
The appliance is equipped with two replaceable bottles of 600ml each (9) for preparing and
storing fresh fruit and vegetable cocktails, as well as milk and protein cocktails. Bottles are
made of top quality BPA free plastic. They have airtight caps (10) with a closable hole for drink-
ing (12) and a handle for carrying (13).
1.
Place the blender housing (2) on a dry, hard and even surface.
2.
Before use check the sealing rings in the cap (10) and the bottle base, (11) and make sure they
are correctly installed.
3.
Cut the products into smaller parts to make mixing easier.
4.
Put the ingredients into the bottle and tighten the mounting base with knives (11) paying
attention to the proper adjustment of the thread.
ATTENTION! Do not fill the bottle above the mark of 600ml. If the ingredients will produce a lot of foam, do not
put too much into the bottle. Suitably reduce the capacity.
NOTE! To maximize efficiency put ingredients into the bottle in the following order: liquids, fresh ingredients,
frozen fruit, yoghurt and ice cream.
5.
Turn over the bottle and place it on the housing together with the
mounting base. Press the bottle and turn it home clockwise. Pay atten-
tion to the marks on the appliance (fig. 2).
ATTENTION! Knives of the appliance are sharp. Handle them carefully.
To disassemble the blender bottle reverse the assembly procedure.
ATTENTION! Do not use the appliance with an empty container!
Fig. 2.