IDE2PCC
User Manual
IDE2PCC
The IDE2PCC is a cost effective and easy to use adapter for connecting PCMCIA PC Cards ATA with true IDE interface
(PC Cards) to the standard IDE port of a single board computer (SBC) from MPL or other manufacturers.
For mechanical fixing in MPL’s PIP family, the IDE2PCC can be connected to the PC/104 slot. The PC Card slot is then
available on the right side of the PIP case. For mounting on top of other SBCs, the mounting holes defined in the PC/104
specification are available.
The IDE signals are connected to the IDE2PCC via a standard 40 or 44 pin IDE cable. The power is distributed either
with the 44 pin IDE cable or through the PC/104 connector.
There are two standard variants of the IDE2PCC available. Others are possible on request:
IDE2PCC-1A44: With PC Card interface, 44 pin IDE connector and PC/104 connector.
(For PIPx / MIPx with the possibility to install an additional PC/104 card on top of it, no 12 V
PC Card support).
IDE2PCC-1N44: With PC Card interface, 44 pin IDE connector without PC/104 connector
(For general use with any kind of SBC with IDE port, no 12 V PC Card support).
At the time of writing of this manual the following MPL products are supported:
•
PIP405
•
The full MPL PIP-Product Range
•
MIP405
•
MIP520
Features:
•
Easy to use & inexpensive
•
PC/104 form factor
•
Optional separate power connector
•
44 pin (optional 40 pin) IDE connector
•
Master / Slave selection possible
•
Optional 2 PC Card Slots (Master & Slave)
•
For bigger order quantities several assembly options are available. Please feel free to contact MPL AG
for further information.
2003 by MPL AG
1
High-Tech • Made in Switzerland
