5 PSF/MVS AFP Printing Using TCP/IP
This chapter provides information on how to create MVS definitions for printing
from PSF/MVS via TCP/IP. The following topics are addressed:
JES printer statements
PSF Startup procedure
Once these parameters have been configured, and the basic TCP/IP installation of
the PrintServer (equipped with an IPDS DIMM) has been completed, direct AFP /
IPDS from PSF / MVS will be possible.
Requirements:
•
PSF/MVS version 2 Release 2.0 with APAR OW15599.
•
MVS Scheduler APAR OW12236 which supports the PRINTDEV IPADDR and
PORTNO keywords.
•
IBM TCP/IP Version 3 Release 1, or higher, installed and configured on
MVS.
Co-requisite supported TCP/IP controller is also required (e.g. IBM 3172).
MTU size:
•
The Maximum Transmission Unit (MTU) of the IP packet for the MVS
system is recommended to be set up to 2000.
Note: The MTU size should not exceed the maximum size sent through the
control unit. Failure may lead to transmission problems.
5.1 PSF/MVS direct attachment
Sample PSF/MVS JES2 initialisation statements
FSSDEF(FSS1)PROC=PSF4,HASPFSSM=HASPFSSM
PRT420
FSS=FSS1,MODE=FSS,PRMODE=(LINE,PAGE),
CLASS=A,UCS=0,SEP,NOSEPDS,CKPTPAGE=100,DRAIN,WS=(R,Q/FCB)
Example of PSF/MVS JES2 printer definition
5.2 PSF/MVS startup procedure
//PSF4 PROC
//STEP01 EXEC PGM=APSPPIEP,REGION=1750K
//JOBHDR OUTPUT PAGEDEF=V06483, /* JOB SEPARATOR PAGEDEF
*/
// FORMDEF=A10110,CHARS=GT15 /* JOB SEPARATOR FORMDEF
*/
//JOBTLR OUTPUT PAGEDEF=V06483, /* JOB SEPARATOR PAGEDEF
26
