MPC 4000 GEN II SERIES LOCK BAR MECHANICAL PANEL CONTROL INSTALLATION AND OPERATION
Page 2 / 26
90-891909001 AUGUST 2005
!
WARNING
WARNING ‑ indicates a potentially hazardous situation that, if not avoided, could result
in death or serious injury.
!
CAUTION
CAUTION ‑ indicates a potentially hazardous situation that, if not avoided, may result
in minor or moderate injury or property damage. It may also be used to alert against
unsafe practices.
IMPORTANT: Indicates information or instructions that are necessary for a particular
step or action.
NOTE: Indicates information that helps in the understanding of a particular step or action.
Selecting Remote Control Cables
Mercury ‑ Mariner ‑ Force ‑ Mercury MerCruiser
Refer to the Mercury Precision Parts Accessories Guide for the available shift and throttle
cables for your application. This control requires the use of Mercury/Quicksilver GEN II
shift and throttle cables.
IMPORTANT: Remote control cables must be the correct length, sharp bends on
too‑short cables result in kinks; too‑long cables require unnecessary bends and/or loops.
Both conditions place extra stress on the cables.
IMPORTANT: Shift cable/throttle cable lubrication points use 2‑4‑C With Teflon.
17431
95
95
95
95
b
c
a
a -
Remote control end
b -
Engine end
c -
Adjusting barrel
Tube Ref No.
Description
Where Used
Part No.
95
2-4-C with Teflon
Shift cable/throttle cable
lubrication points
92-802859A1
NOTE: Allow for clearance of cables directly behind panel mount remote control. The
4000 GEN II Series Panel Mount Remote Control mounting surface must not exceed
25.4 mm (1 in.) thickness. Cable radius at any one point must not be less than
305 mm (12 in.).