MPBTB 130 Iss 1
Page 1 of 10
MPB SERIES TX200 TRANSMITTING FLOWMETER
Instruction Manual
CONTENTS
1
INTRODUCTION
2
TECHNICAL
3
INSTALLATION
3.1 Electrical connections
4
OPERATION
4.1
Transmitter board
4.2
Applying Power to the Transmitter for the
first time
4.3
Calibrating the Transmitter
4.4
Setting Flow Rate Alarms
4.5
Extended output range
– NAMUR 43
4.6
Special Output Current Capabilities
4.7
Power On Delay
4.8
ID/Serial Number
4.9
Setting Flow Rates and Flow Rate Units
4.10
Flow Volume and Flow Volume Alarm
4.11
Flowmeter Runtime Values
4.12
RS485 Full-Duplex Communications
4.13
Alarm Relay Configuration
5
MAINTENANCE
6
TROUBLE SHOOTING
7
WARRANTY
8
ILLUSTRATIONS
MPVA 2050 Overall dimensions
MPVA 2051 Overall dimensions with wall mounting bracket
1
INTRODUCTION
The TX200 Flowmeter is for use with many types of gases. Parts in contact with gases are of a 316 (A4)
stainless steel construction. The enclosure for the pointer and interface board is produced from an
aluminium billet with a hard anodised coating.
All versions have an analogue pointier and graduated scale display. This can be a percentage display
(0
–100%), or a calibrated scale to suit customer requirements.
The TX200 Flowmeter can be fitted with a rotary encoder. This gives 4-20mA output that reflects the
specific flow rate of the flowmeter.