Moyer Diebel DF, Technical Manual

Page: 15 / 46

13
MAINTENANCE
MAINTENANCE
CLEANING
Daily Cleaning Instructions
1. Remove the drain tray/waste collector (if installed), from the front of your glasswasher.
2. Turn glasswasher off by flipping the toggle switch located on the wash tank to the “OFF”
position.
3. Remove right and left hand trays and splash curtain. Wash them with hot soapy water, rinse
thoroughly, then dry.
4. Remove the conveyor as follows: Remove cylinder in center of conveyor, flip shut-off rod
to the side, lift conveyor from center and pull out.
5. Remove lower wash and rinse arms. Clean wash and rinse areas with hot soapy water.
Rinse thoroughly, then dry.
6. Replace lower wash and rinse arms (they only fit one way). Replace conveyor as follows:
With back end of conveyor raised, mesh drive gear with side of conveyor, pull conveyor
towards you until center of conveyor drops onto pivot. Replace cylinder in center of
conveyor, flip shut-off bar back to normal position. Replace left hand tray ensuring shut-off
arm rests within the retainer, then replace right hand tray. Replace curtain.
7. Remove and clean upper and lower wash tank screens.
8. Remove stand pipe from the detergent tank, wash down the interior of the detergent tank.
Replace stand pipe and upper and lower wash tank screens.
NOTE:
Do not leave water in tank overnight!!!
9. Replace drain tray/waste collector (if installed) making sure hose is connected.
10. Ensure there is product in the detergent, sanitizer and rinse agent containers. Close door.
Weekly Cleaning Instructions
1. Remove upper and lower wash and rinse arms from the manifold and clean spray tubes
with reamer, tube brush, and tube scraper provided.
2. Remove detergent, sanitizer, and rinse agent feed lines from containers and place them in a
container of hot water. Hold prime buttons in until the feed lines have been thoroughly
flushed. Replace the feed lines to their proper container and prime product through lines.