12
Step 4 –Secure Leg Support to Top Rail
Secure Vertical Leg Extension (part 5) to the frame (parts1, 2 & 3) using Phillips
Pan Head Tapping Screws (part 20), Spring Lock Washer (part 17) and Hex Key
(part 31) as shown below. If the holes do not match up, rotate Vertical Leg Extension
back and forth until the holes are aligned. Repeat in the same manner for all
Leg Supports.
NOTE:
Do not over-tighten the screws at this point. The screws should only be
tightened all the way after all the springs have been installed in later steps
HINT:
Make sure the holes on all the steel tubing parts are aligned and the larger
indented hole on #6B is facing outward. This is important for installing the
enclosure later.
The hole must
face outward
