- 10 -
DIN-Rail Mounting
The aluminum DIN-Rail attachment plate should already be attached to the
back panel of the VPort D351 when you take it out of the box. If you need to
reattach the DIN-Rail attachment plate to the VPort D351, make sure the stiff
metal spring is situated towards the top, as shown in the figures below.
STEP 1
:
Insert the top of the DIN-Rail into the
slot just below the stiff metal spring.
STEP 2
:
The DIN-Rail attachment unit will snap
into place as shown below.
metal
spring
DIN-Rail
metal
spring
DIN-Rail
To remove the VPort D351 from the DIN-Rail, simply reverse Steps 1 and 2
above.
Wall Mounting (Optional)
For some applications, you will find it convenient to mount the VPort D351 on
the wall, as illustrated below.
STEP 1
:
Remove the aluminum DIN-Rail attachment plate from the VPort D351, and
then attach the wall mount plates, as shown in the diagrams below.
⇒
Top
plate
Bottom
plate
STEP 2
:
Mounting the VPort D351 on the wall requires 4 screws. Use
the VPort D351, with wall mount plates attached, as a guide
to mark the correct locations of the 4 screws. The heads of
the screws should be less than 6.0 mm in diameter, and the
shafts should be less than 3.5 mm in diameter, as shown in
the figure at the right.
Do not screw the screws in all the way—leave a space of
about 2 mm to allow room for sliding the wall mount panel
between the wall and the screws.
6.0 mm
3.5 mm
