UC-8410/8416/8418/8430 Hardware User's Manual
Hardware Connection Description
4-3
SG:
The
Shielded Ground
(sometimes called
Protected Ground
) contact is the right most
contact of the 3-pin power terminal block connector when viewed from the angle shown here.
Connect the SG wire to an appropriate grounded metal surface.
ATTENTION
A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference
to nearby radio and television reception. It is essential that only the supplied power cord be used.
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
Connecting to VGA Monitors (UC-8430 only)
The UC-8430 comes with two D-sub 15-pin female connectors on the rear panel to connect two VGA monitors.
To ensure that the monitor image remains clear, be sure to tighten the monitor cable after connecting it to the
UC-8430. The pin assignments of the VGA connectors are shown below.
DB15 Female Connector
Pin No.
Signal Definition
1
Red
2
Green
3
Blue
4
NC
5
GND
6
GND
7
GND
8
GND
9
VCC
10
GND
11
NC
12
DDC2B Data
13
HSYNC
14
VSYNC
15
DDC2B Clock
Summary of Contents for UC-8410
Page 15: ...UC 8410 8416 8418 8430 Hardware User s Manual Appearance and Dimensions 2 7 UC 8416 Unit mm ...
Page 16: ...UC 8410 8416 8418 8430 Hardware User s Manual Appearance and Dimensions 2 8 UC 8418 Unit mm ...
Page 17: ...UC 8410 8416 8418 8430 Hardware User s Manual Appearance and Dimensions 2 9 UC 8430 Unit mm ...
Page 19: ...UC 8410 8416 8418 8430 Hardware User s Manual Appearance and Dimensions 2 11 UC 8418 UC 8430 ...
