DA-660-8/16-LX User’s Manual
Managing Communications
4-5
IPTABLES
IPTABLES is an administrative tool for setting up, maintaining, and inspecting the Linux kernel’s
IP packet filter rule tables. Several different tables are defined, with each table containing built-in
chains and user-defined chains.
Each chain is a list of rules that apply to a certain type of packet. Each rule specifies what needs to
be done with a matching packet. A rule (such as a jump to a user-defined chain in the same table)
is called a
target
.
The DA-660 supports 3 types of IPTABLES table:
Filter
tables,
NAT
tables, and
Mangle
tables:
A.
Filter Table
—includes three chains:
INPUT chain
OUTPUT chain
FORWARD chain
B.
NAT Table
—includes three chains:
PREROUTING chain—transfers the destination IP address (DNAT)
POSTROUTING chain—works after the routing process and before the Ethernet device
process to transfer the source IP address (SNAT)
OUTPUT chain—produces local packets
sub-tables
Source NAT (SNAT)—changes the first source packet IP address
Destination NAT (DNAT)—changes the first destination packet IP address
MASQUERADE—a special form for SNAT. If one host can connect to internet, then
other computers that connect to this host can connect to the Internet even if these
computers does not have an actual IP address.
REDIRECT—a special form of DNAT that re-sends packets to a local host independent
of the destination IP address.
C.
Mangle Table
—includes two chains
PREROUTING chain—pre-processes packets before the routing process.
OUTPUT chain—processes packets after the routing process.
It has three extensions—TTL, MARK, TOS.
The following figure shows the IPTABLES hierarchy.
