- 3 -
Hardware Introduction
As shown in the following figures, the MGate MB3480 has 4 DB9 male
ports for transmitting serial data.
Reset Button—
The reset button is used to load factory defaults. Hold
the reset button down for five seconds using a pointed object such as a
straightened paper clip. Release the reset button when the Ready LED
stops blinking in order to load the factory defaults.
LED Indicators—
Six LED indicators are located on the top panel:
Name
Color
Function
Ready
Red
Steady on: Power is on and the unit is booting up.
Blinking: IP conflict exists, or DHCP or BOOTP
server did not respond properly.
Green
Steady on: Power is on and the unit is functioning
normally.
Blinking: Unit has found by the Location
command in MGate Manager.
Off
Power is off or power error condition exists.
Link
Orange
10 Mbps Ethernet connection.
Green
100 Mbps Ethernet connection.
Off
Ethernet cable is disconnected or has a short.
P1/P2/
P3/P4
Orange
Unit is receiving data from device.
Green
Unit is transmitting data to device.
Off
No data is being exchanged with device.
