– 1 –
– 2 –
– 3 –
P/N: 1802063240012
Industrial Rackmount Switch
IKS-6324 Series
Hardware Installation Guide
Third Edition, September 2013
Package Checklist
The Moxa IKS-6324 Series industrial rackmount switches are
shipped with the following items. If any of these items is missing or
damaged, please contact your customer service representative for
assistance.
•
1 Moxa IKS-6324 Switch
•
Hardware Installation Guide
•
Moxa Product Warranty Statement
•
Protective caps for unused ports
•
2 rack-mount ears
Panel Layouts
1.
LED Indicators (System status, Interface Module mode,
Interface Module port)
2.
Push-button switch to select mode for Interface Module
3.
Model Name
4.
Fast Ethernet / Gigabit Ethernet Interface Modules
5.
10/100BaseT(X) port
6.
10-pin terminal block for power inputs
7.
Rack Mounting Kit
8.
Ground Screw
Dimensions (unit = mm)
Fast Ethernet Interface Module
Gigabit Ethernet Interface Module
Slot 1 for 2-port PM-7200 Gigabit
Ethernet combo module, or 2- or 1-port
PM-7200 fast Ethernet modules.
Rack Mounting
Use four screws to attach the switch to a standard rack.
Wiring Requirements
WARNING
Safety First!
Be sure to disconnect the power cord before installing
and/or wiring your Moxa industrial rackmount switch.
Calculate the maximum possible current in each power wire
and common wire. Observe all electrical codes dictating the
maximum current allowable for each wire size. If the
current goes above the maximum ratings, the wiring could
overheat, causing serious damage to your equipment.
Grounding Moxa’s Rackmount Switches
Grounding and wire routing help limit the effects of noise due to
electromagnetic interference (EMI). Run the ground connection
from the ground screw to the grounding surface prior to connecting
devices.
ATTENTION
This product is intended to be mounted to a well-grounded
mounting surface, such as a metal panel.
Wiring the Power Inputs
The IKS series supports dual redundant power supplies, named
“Power Supply 1 (PWR1)” and “Power Supply 2 (PWR2)”. The
connections for PWR1 and PWR2 are located on the terminal block.
Front view of the terminal block connectors are shown here.
