- 5 -
Removal
STEP 1
—Pull down the latch on
the mounting kit with a
screwdriver.
STEP 2 & 3
—Slightly pull the
EDS device forward and lift up to
remove it from the DIN rail.
NOTE
Our DIN rail kit now utilizes a quick release mechanism to make
it easier for users to remove the DIN rail from the EDS device.
Wall Mounting (Optional)
For some applications, you will find it convenient to mount the Moxa
EDS device on a wall, as shown in the following illustrations:
STEP 1—
Remove the DIN-rail
attachment plate from the rear
panel of the EDS device, as
illustrated in the diagram on the
right.
STEP 2—
Mounting the EDS device on a wall
requires six screws. Use the EDS device, with wall
mount plates attached, as a guide to mark the
correct locations of the six screws. The heads of the
screws should be less than 6.0 mm in diameter,
and the shafts should be less than 3.5 mm in
diameter, as shown in the figure on at right.
NOTE
Before tightening the screws into the wall, make sure the screw
head and shank size are suitable by inserting the screw through
one of the keyhole-shaped apertures of the Wall Mounting
Plates.
