AirWorks AWK-3131-RCC
Web Console Configuration
3-10
Client Isolation (for AP mode only)
Client isolation is used to isolate the associated wireless clients in one or more APs. Isolated clients cannot
communicate with each other, so the level of security is increased. Depending on the type of client isolation, you
may also define the exception clients inside the isolation network. It can be used in server access.
Client Isolation
Setting
Description
Factory Default
No isolation
No isolation is applied.
No isolation
Isolated within the
same AP
All clients associated to this AP will be isolated from each other.
Isolated within the
same subnet
All clients in the specified subnet will be isolated from each
other. The subnet is defined by the following two parameters,
gateway and netmask.
Gateway
Setting
Description
Factory Default
Gateway for client
isolation function
This setting is used when “Isolated within the same subnet” is
selected. Gateway and netmask are used to define the network
in which wireless clients will be isolated from each other.
None
Netmask
Setting
Description
Factory Default
Netmask for client
isolation function
This setting is used when “Isolated within the same subnet” is
selected. Gateway and netmask are used to define the network
in which wireless clients will be isolated from each other.
None
“Allowed subnet with TCP/UDP port” settings are used to define the exception subnets (or hosts) when
“Isolated within the same subnet” is selected. Up to eight subnets or hosts can be defined.
Active
Setting
Description
Factory Default
Enable/Disable
This checkbox enables or disables the rule for allowed subnet
settings.
Disable
IP
Setting
Description
Factory Default
IP address for allowed
subnet definition
The IP address of the subnet definition. Hosts in this subnet can
be accessed by other hosts or wireless clients in the same
subnet.
None
www.ipc2u.ru
www.moxa.pro
