- 4 -
Wall Mounting (optional)
The optional wall-mounting kit is not included in the product package
and should be purchased separately.
Follow these steps to mount the device on to a wall.
STEP 1:
Attach the wall-mounting
brackets to the rear side of
the AIG-501-T-AZU-LX by
using two screws per bracket.
STEP 2:
Use four screws per side on
the wall-mounting bracket to
attach the AIG-501-T-AZU-LX
to a wall or cabinet.
IMPORTANT!
The diameter of the screw heads should be greater than 7 mm
and less than 14 mm; the diameter of the shafts should be less
than 3 mm. The length of the screws should be greater than 6
mm.
NOTE
•
Test the screw head and shank size by inserting the screws
into one of the keyhole shaped apertures of the wall-
mounting plates before attaching the plate to the wall.
•
Do not drive the screws in all the way—leave a space of
about 2 mm to allow room for sliding the wall-mounting
panel between the wall and the screws.
Wiring Requirements
•
Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
•
You can use the type of signal transmitted through a wire to
determine which wires should be kept separate. The rule of thumb
is that wiring that shares similar electrical characteristics can be
bundled together.
•
Keep input wiring and output wiring separate.
•
When necessary, it is strongly advised that you label wiring to all
devices in the system.
