23
4.
4.
4.
4.
Using the Movexx (see fig.1)
Using the Movexx (see fig.1)
Using the Movexx (see fig.1)
Using the Movexx (see fig.1)
Before taking the Movexx T1000-D into use, this manual has to be carefully read and fully
understood by the person that will operate the machine. Control if the Movexx T1000-D is
in a good shape, it may not be damaged or be incomplete. The standard Movexx T1000-D is
delivered with a special adjusted couple piece(9), a power pack and a loader
Turn the engine off and take the key out. Pull of the power pack from the machine and place
the plug into the loader in order to recharge the power pack.
When the Power pack is fully loaded, place the Power pack back in the Movexx and turn the
machine on with either the button or with the contact key. In case of a contact key, turn the
key clockwise. By doing so the orange LED on the loading meter is going to lighten up.
Take your position before the steering wheel and position both hands on the handles. Push
with your right or left thumb on the topmost of the driving switch and push it gently
forwards. The unit starts moving forwards. Let go of the button. Push with your thumb on
the bottom of the driving switch and the unit will move towards you (backwards).
Let the Movexx T1000-D move towards you and don’t move yourself. Drive until the red
emergency button touch your chest. The Movexx T1000-D stops now and as a result it
immediately drives a way from you for approximately 10 cm.
(Option) Push on the horn button and control if the horn is working.
If the above mentioned functions are working well, than the Movexx T1000-D is ready for
use. In any case of malfunctioning contact the technical service and let them check the
Movexx T1000-D before you are going to work with it.
5.
5.
5.
5.
Charging the Power pack(s)
Charging the Power pack(s)
Charging the Power pack(s)
Charging the Power pack(s)
Place the Movexx T1000-D close to the 220V electricity contact.
Turn the Movexx T1000-D off.
Pull the power pack of the machine.
Push the plug from the loader to the contra plug of the Power pack.
Connect the loader to the net and turn the loader on.
Recharge according the guidelines as explained in the manual from the recharge equipment.
When the power pack is fully charged, repeat above mentioned in the reverse order and the
Movexx T1000-D is ready to use.
The power pack should also be charged on a regular basis if the machine is not being used.
Make sure that the loader itself is taken out of the electricity contact so that is will reset
itself. If you don’t do this then the loader won’t erase its memory after each charging session
and won’t charge the power pack as it should.