BEFORE EACH USE
Always ensure that the mower is in a safe working condition. Inspect
the cutter blade for damage; check safety devices and guards; check
that all nuts, bolts and screws are secure.
Check the oil level as follows:
a) Remove the Oil Filler/Dipstick and wipe the dipstick clean (Figure
b) Remove the dipstick again and check the oil level is at the
Maximum mark.
oil level should not be above the Maximum mark or below the Minimum
mark. The oil tank capacity is about 0.55litre.
be below the bottom of the fuel tank neck.
Stop the engine and disconnect the spark plug lead before working on the machine. DO NOT TIP
THE MOWER ONTO ITS SIDE AS THIS WILL FLOOD THE AIR FILTER WITH OIL. To access the
underside of the machine, lift the front wheels by lowering the handle until it rests on the ground.
CUTTER BLADE
Examine the cutter blade regularly for wear or damage.
A slightly worn blade can be re-sharpened by your local dealer.
stockist. The part number for the blade kit is MS119
8. If in doubt refer to
your dealer, or telephone 0845 600 2912. Blades must always be marked
81004381/1.
CLUTCH CABLE ADJUSTMENT (Self Propelled model only)
Make sure that the clutch lever is fully released.
Lengthen the cable adjuster by unscrewing it a couple of turns. (Figure 7)
Engage the clutch lever and check that the rear wheels lock when the mower
is pulled backwards.
Start the mower and ensure it does not drive when the lever is disengaged.
ENGINE
An engine manufacturer’s Owner’s Manual is supplied with your mower. Please
read this, it provides detailed information on engine operation and maintenance.
Repair work other than routine maintenance, should be carried out by an authorised dealer.
STORAGE
A little time spent on your mower after use will ensure many years of reliable mowing. To access the underside of
the cutter deck, ensure the spark plug lead is disconnected, then lift the front wheels by lowering the handle until
AFTER EACH USE
Remove any grass pulp from the underside of the cutter deck using a non-metallic instrument such as a piece
of wood. Take care not to damage the paintwork.
Examine the cutter blade for any damage. A damaged blade may upset the balance of your mower and cause
excessive vibration, if in doubt refer to your dealer.
impair grass collection.
The handle can be folded down to reduce the amount of storage space required. Take care not to trap any of
the operating cables when folding or unfolding the handle.
LONG TERM - If you are not using your mower for more than 28 days.
Give the machine a thorough clean, paying particular attention to the underside.
Lubricate all moving parts.
At the end of the season, empty the fuel tank either by running the mower out of fuel or tip the machine
backwards and onto the back right wheel to drain the fuel into a suitable container. Drain the carburettor by
loosening the drain screw, retighten the drain screw.
MAINTENANCE
Cable
Adjuster
18
Figure 7
Figure 6
OIL FILLER CAP/
DIPSTICK
LOWER LIMIT
UPPER LIMIT
Summary of Contents for SP535
Page 2: ......