Mountfield 2L0536043/MC, Operating Instructions Manual, Page: 22 / 36

EN - 7
9. HANDLING AND TRANSPORTATION
Whenever the machine is to be handled, raised, transported
or tilted you must:
• Stop the machine (par.6.5) until the moving parts come to a
complete halt.
• Remove the spark plug cap (Fig.23.B) or remove the key
(Fig.23.D) or the battery (for models with push-button
electric start command).
• Wear heavy work gloves.
• Hold the machine in the points offering a safe grip, taking
into account the weight and its division.
• Use an appropriate number of people for the weight of the
machine and the characteristics of the vehicle or the place
where it must be placed or collected.
• Make sure that machine movements do not cause damage
or injuries.
When transporting the machine on a vehicle or trailer, always:
• Use an access ramp of suitable strength, width and length.
• Load the machine with the motor switched off and pushed by
an adequate number of people.
• Lower the cutting blade assembly (par 5.5).
• Position it so that it cannot cause a hazard for anybody.
• Fasten firmly to the device of transport using ropes or chains
to prevent it from tipping over causing damage and fuel
leaks.
Do not transport machines that can be stored
vertically in this upright position.
10. MAINTENANCE TABLE
Intervention Frequency Notes
MACHINE
Check all fasteners ; Safety checks/check controls; Check the rear/side discharge
guards; Check the grass catcher bag and side discharge chute; Check the cutting
blade.
Before use par. 6.2.2
General cleaning and inspection ; Checking for any damage to the machine.
If necessary, contact a Mountfield authorised service dealer.
After each use par. 7.4
Replacing the cutting means - par. 7.3.1 ***
ENGINE
Checking/topping up the fuel level; Check/top-up the engine oil Before use par. 6.1.1 / 7.2.1 * / 7.2.2 *
Air filter check and clean; Spark plug contacts check and clean; Spark plug
replacement; Charging the battery
* * / par. 7.5 *
* Refer to the engine manual. *** Operation to be performed at the first signs of any malfunction
*** The operation must be carried out by your Dealer or a Mountfield Authorised Service Dealer