STEP 43: Insert the elevator control horn
through the hole in the fuselage top and slide it
onto the elevator pushrod Z-bend. This can be
a bit tricky, but take it slowly and you'll get it.
Alternatively, you could pull the pushrod out
through the hole with some needle nose pliers,
hook up the elevator control horn, and then
press it back into the fuselage.
STEP 44: Glue the vertical fin to
the stab, making sure that the fin
is perpendicular to the stab and
is fully seated. You can use thick
CA or a THIN application of
epoxy. The 2 tabs on the vertical
will be sticking out the bottom
of the stab. These tabs will
properly align the stabilizer to
the fuselage.
STEP 45: Glue the stabilizer/vertical fin
assembly to the fuselage, making sure it is level
on the fuselage. You can use thick CA or a
THIN application of epoxy. MAKE sure the
vertical fin is aligned, vertically, with the pylon.