Page 7
A-Series Digital Game Cameras
Page 2
A-Series Digital Game Cameras
Mounting with a Strap
Close cover and place camera on a tree or pole
approximately 3 ft. high. Thread the mounting strap
through the mounting strap slots on the back of the
camera and secure.
Hint:
If you are mounting camera to cover a trail,
face the camera down the trail tilted at a slight
downward angle.
Face the camera North or South to avoid
over exposure from the sun.
Clear brush away from camera front to
avoid false triggers from the wind.
Battery Installation
Open the camera cover and install 8 AA Alkaline or Lithium batteries. Make sure that the
(+ and -) polarities match the polarities indicated inside the battery chamber.
Note:
Anytime you load or unload batteries, make sure that the camera is OFF. If using 12V DC
Power Panel Plug, do not remove internal batteries.
Insert SD Card
You will need to open the front cover to insert an
SD memory card. You can insert a SD Card up to 32 GB.
Insert the SD card in the direction indicated on the card,
until you hear an audible click.
Note:
Camera will not operate without an SD memory
card installed.
Power ON
Slide the
Mode
Switch to the
ON
position.
The battery level will appear on the LCD Display for
~2 seconds. The camera will then begin to countdown.
Upon reaching 0, the camera will enter capture mode
and display will turn off.
Camera Setup
Battery Installation
Open the camera cover and install 4 C-Cell
Alkaline batteries. Make sure that the
(+ and _) polarities match the polarities
indicated inside the battery chamber.
Note: Anytime you load or unload batteries,
make sure that the camera is OFF. If using
12V DC Power Panel Plug, do not remove
internal batteries.
Insert SD Card
You will need to open the front cover to
insert a SD memory card. You can insert a
SD Card up to 32 GB. Insert the SD card in
the direction indicated on the card, until you
hear an audible click.
Note: Camera will not operate without
an SD memory card installed.
Power ON
Slide the (Mode) Switch to the (Setup)
position. Press and hold the (ON/OFF)
Button until the time appears on the LCD
Display. The camera will power up.
Mounting with a Strap
Close cover and place camera on a tree or
pole approximately 3 ft. high. Thread
the mounting strap through the mounting
strap slots on the back of the camera
and secure.
Hint: If you are mounting camera to cover a
trail face the camera down the trail tilted at
a slight downward angle.
Face the camera North or South to avoid
over exposure from the sun.
Clear brush away from camera front to
avoid false triggers from the wind.
NO
Trail
YES
Trail
7
Moultrie Mobile® Compatibility
Your camera is compatible with our Moultrie Mobile® cellular
service when combined with the Field Modem MV1.
Please visit
www.moultriemobile.com
for more information.
NOTE: Camera firmware update may be required
for full Moultrie Mobile functionality.
Using the Moultrie Camera Power Panel
Place near the tree where the camera is mounted. Place for best
exposure to sun. To attach to a tripod secure the power panel
to the tripod angled upward for best exposure. Plug the power
panel to the Power Panel Plug. This will extend the life of your
camera in the field.
Note:
Leave internal batteries in the camera during use.
The Camera Power Panel needs 4 hours of sunlight to fully
power the camera.
Using the Moultrie Battery Box
Extend the field life of your Moultrie camera with a
long-lasting, rechargeable external power source.
Place near the tree where the camera is mounted.
Plug the Battery Box to the Power Panel Plug.
This will extend the life of your camera in the field.
MOULTRIE ACCESSORIES
(Sold Separately)
E
QUICK START INSTRUCTIONS
B
