![background image](http://html.mh-extra.com/html/moulinex/lm1a0-series/lm1a0-series_manual_1839791027.webp)
27
EN
Mixing starts as soon as the blender bottle
(B)
is pressed down into the motor unit
(A)
Fig.3.
Press down until mixing is complete. Mixing stops once the bottle is released. The maximum
continuous operating time is 30 seconds, followed by a break of 10 minutes.
This appliance is not suitable for mixing potatoes, cream, egg whites, dough, etc.
The appliance must not be used with hot liquids, as the pressure at the base will be too great.
The appliance must not be used with ice cubes.
If the motor stops during use, unplug the appliance and remove the blender bottle
(B)
from the
motor unit
(A)
. Let the appliance rest for at least 10 minutes before starting it again.
Once you have finished mixing, turn the blender bottle upright so that the blade unit
(B1)
is
at the top and then unscrew it from the blender bottle
(B3)
Fig.4. Then place the rubber seal in
the lid, and screw on the lid
(C1+C2)
provided Fig.5. The blender bottle is ready to drink from
or take with you.
CLEANING YOUR APPLIANCE
Unplug the appliance and remove the blender bottle
(B)
.
Handle the blender unit with care because the blade is sharp.
Rinse the blender bottle
(B3)
and blade unit
(B1+B2)
immediately after use under running water
and also the detachable parts in warm water and a little washing-up liquid.
For easier cleaning, the blade unit
(B1)
can be detached from the bottle
(B3)
by unscrewing.
The blender bottle
(B3)
, blade unit
(B1)
, without the seal
(B2)
, and lid
(C2)
can be washed in
the top basket of the dishwasher using the “ECO” or “LIGHT WASH” programme.
To clean the motor unit
(A)
, use a damp cloth and dry it carefully.
Never immerse the motor unit
(A)
in water or any other liquid.
Cleaning the rubber seal:
When cleaning the blade unit, the rubber seal must be removed from the blade unit to remove
any food residues.
1. Unscrew the blade unit
(B1)
from the bottle
(B3)
. (Note that the blades are very sharp.) Turn
the blade unit
(B1)
upside down and press the plastic stick
(D)
provided into the small hole
on the underside of the blade unit. Fig.6.
2. The seal will then loosen from the top of the blade unit and can now be cleaned with water
and a little washing up liquid.
3. Clean the seal and blade unit carefully (the blade unit only, without the seal, is dishwasher
safe) and replace the seal in the slot on the blade unit. Make sure that the seal forms a tight
seal around the base of the blade unit by pressing it down with the blunt end of the plastic
stick. There is a risk of leakage if the seal is not correctly replaced.