S O N A R A N D O T H E R W D M S O F T W A R E
39
The “Phones 1-2” output
If you’ve chosen to treat the 8pre headphones as an
independent output, you’ll see
Phones 1-2
as a 8pre
output destination. Audio tracks assigned to this
output pair will be heard on the headphone jack
only. For further explanation, see “Phones” on
page 26.
CHANGING 8PRE SETTINGS
You can change the 8pre settings at any time by
accessing MOTU Audio Setup.
REDUCING DELAY WHEN MONITORING
LIVE INPUTS
If you have live audio inputs connected to the 8pre,
such as MIDI synthesizers, samplers, microphones
or other live instruments, you might hear a slight
delay when their audio is being monitored through
your 8pre hardware and your host audio program.
There are several ways to reduce — and eliminate
— this audible monitoring delay. For details, see
chapter 10, “Reducing Monitoring Latency”
(page 45).
MIDI I/O VIA THE 8PRE MIDI PORTS
Once you’ve run the 8pre’s software installer as
explained in “Installing the 8pre software” on
page 15, the 8pre MIDI ports will appear as a input
source and output destination in the MIDI input
and output menus of your WDM-compatible host
software.
24-BIT OPERATION
Your 8pre hardware fully supports 24-bit recording
in any audio software that supports it. Simply
enable 24-bit operation as instructed by the
software. The 8pre system always supplies the
software with a 24-bit data stream, and when you
enable 24-bit operation, it simply uses all 24-bits
supplied by the 8pre hardware.
Summary of Contents for 8pre
