Motortech EasyNOx, Operating Manual

Page: 82 / 142

8 General Operation
82 Rev. 06/2021
Operational safety!
Testing the binary outputs affects the connected devices. Before performing
tests, make sure that switching the binary outputs will not result in hazards
or damage.
– Demo
To access the device-specific pages for demonstration or pre-configuration without the de-
vice being connected, you can activate and deactivate the demo mode by tapping the but-
ton. The demo mode is indicated in the information bar in the logo by the text
Demo Mode .
Operational safety!
The demo mode is not a normal operating state of the EasyNO
ₓ
. In combina-
tion with other devices the EasyNO
ₓ
must not be operated in demo mode.
8.4.1.1 Device Activation
Device activation of EasyNO
ₓ
packages
In an EasyNO
ₓ
package for two engines, both NO
X
monitors have been acti-
vated in the EasyNO
ₓ
ex works.
If you purchase a second engine extension package for an EasyNO
ₓ
package
supporting one engine, a software dongle is included with this extension
package. This software dongle activates the second NO
X
monitor of the
EasyNO
ₓ
.
For certain devices, activation is required in order to add and use them in the EasyNO
ₓ
. You can
add activated devices to the device configuration of your EasyNO
ₓ
in the Device Setup view (see
section Adding a Device on page 83).
All devices with which you have purchased the EasyNO
ₓ
are normally activated ex works (e.g. the
first and second NO
X
monitor in an EasyNO
ₓ
package for two engines). You can retrofit additional
devices by purchasing a software dongle from your MOTORTECH contact person (see Customer
Service Information on page 132). With this software dongle, you then activate the respective
device in your EasyNO
ₓ
. After activation, you can add the device to the device configuration of
your EasyNO
ₓ
.