11 Errors
132
Rev. 06/2021
Fault
Possible cause
Solution
The device cannot be
added, although the above
symbol appears next to the
device in the
Add Device
dialog.
The number of available
activations for this device
has been exceeded.
Activate the additional device
with a software dongle (see sec-
tion
Device Activation
on
When tapping on a device in
the
Start Menu
, you get the
error message "No connec-
tion to this device has been
established!"
The wiring of the CAN bus
is defective.
Check the CAN bus wiring and cor-
rect any defects found.
The bit rate of the device
does not correspond to
the bit rate of the
EasyNO
ₓ
.
Set the correct bit rate for the de-
vice.
The node ID of at least
one added device is in-
correct.
Set the correct node-ID for the re-
levant device.
11.2
Customer Service Information
You can reach our customer service during business hours at the following phone and fax num-
ber, or by email:
Phone:
+49 5141 93 99 0
Fax:
+49 5141 93 99 99
Email:
Summary of Contents for EasyNOx
