16
English
Press the
CH
/
key to enter the channel setting. Press
OK
then press the
or
key to select the Auto Channel
Change settings or Manual Channel Change settings.
The Display shows the following:
Press the
CH
/
key to enter each setting.
Note:Pressing the
CH
/
key will go back to idle
status.
Auto Channel Change setting
Press the
CH
/
key to enter Group Mode.
Press
OK
to set the Auto Channel change and the display
will show the current group number. Press
OK
then press
the
or
key to select the group channel number press
again the
or
key to select the group mode in "ALL".
Press
OK
to confirm and transmit Auto Channel change
command.
Note:Pressing
CH
/
key will go back to idle status.
Manual Channel setting
Press the
CH
/
key to enter Group Mode. Press
OK
to
set the Manual Channel setting and the display will show
"MY".
Press
OK
then press the
or
key to select the
channel.
Then, Manual channel setting is available.
Note:Pressing the
CH
/
key will go back to idle
status.
Set All/Direct Call
Press the
/
key in Group mode to enter All/Direct call
setting. At first the user selects a type of call from All Call
transmission or Direct Call setting.
To select the setting, press the
or
key to select the
type of a call.
Set All Call
When All Call Transmission " ZYNC" is selected press the
/
key to transmit All Call immediately. Then it sounds
All Call tone to the receiver unit. The display shows TX icon
and Call icon while transmitting.
Note:
Pressing the
CH
/
key will go back to idle status.
Auto Channel
Change
Manual Channel
Change
All Call
Transmission
Direct Call
Transmission
T8_EN.fm Page 16 Thursday, September 16, 2010 12:01 PM
