Motorola T2260, Service Manual

Page: 59 / 121

© 2000 Motorola, Inc.
CDMA 800/AMPS-V2260, T2260
CDMA Dual Mode 800-1900-V2267, T2267
Cellular Subscriber Sector
DISASSEMBLY
Introduction
Care must be taken during the disassembly
and reassembly of the unit in order to avoid
damaging or stressing the housing and inter-
nal components. Ensure that a properly
grounded high impedance conductive wrist
strap is used while
performing these procedures on electronic
units.
Recommended Tools
The following tools are recommended for
use during the disassembly and reassembly
of the phone.
- Anti-Static Mat Kit (0180386A82);
includes:
CAUTION
Many of the integrated circuit devices used
in this equipment are vulnerable to damage
from static charges. An anti-static wrist
band, connected to an anti-static (conduc-
tive) work surface, must be
worn during all phases of disassembly,
repair, and reassembly.
- Anti-Static Mat 6680387A95
- Ground Cord 6680334B36
- Wrist Band 4280385A59
- Plastic Prying Tool SLN7223A
- Rear Housing Removal Tool
- Dental Pick
- Tweezers
- T6 Torque Screw Driver
Disassembly Procedure
Refer to the disassembly instructions and
photo sequence on the following pages.
Assembly Procedure
Once the unit is disassembled and the repair
is carried out it then becomes obvious that to
assemble the unit, the procedure is the
reverse of that previously completed for dis-
assembly.
Antenna Removal
1-1 Turn off the power.
1-2Remove a Rubbor Boot.
1-3 Remove antenna by turning counter-
clockwise.