8
Getting started
4. When the handset is fully charged,
icon will appear steady on the display. Plug the
other end of the telephone line cord (make sure that one end is already plugged into
the base) into the telephone wall socket.
Connecting the handset and charger (for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.
1. Plug the power adaptor into the socket marked on the underside of the charger
and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2 x AAA NiMH
rechargeable batteries supplied. Please note the ’+’ and ’-’ markings inside the battery
compartment and insert in the correct direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on the charger to
charge for at least 24 hours continuously.
5. When the handset is fully charged,
icon will appear steady on the display. The
display will show
HANDSET
and handset number (e.g. 2) to indicate that it is registered
to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH 300mA
rechargeable batteries) supplied with your T2.
Please do not use alkaline or nonrechargeable batteries. It may cause permanent
damage to the product and void the warranty.
BATTERY LOW WARNING
If icon flashes on the display and you hear a warning beep every minute during a call,
you will need to recharge the handset before you can use it again.
