Motorola Symbol DS6878, Product Reference Manual

Page: 98 / 629

5 - 2 DS6878 Product Reference Guide
Scanning Sequence Examples
In most cases scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under
Beeper Tone on page 5-8 . The digital scanner issues a
fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters require scanning several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Option Parameter Defaults
Table 5-1 lists the defaults for preferences parameters. To change the default values:
•
Scan the appropriate bar codes in this guide. These new values replace the standard default values in
memory. To recall the default parameter values, scan the
Default Parameters on page 5-5 .
•
Configure the digital scanner using the 123Scan
2
configuration program (see 123Scan2 on page 13-1 ).
Table 5-1
User Preferences Parameter Defaults
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter Set Defaults 5-5
Parameter Bar Code Scanning ECh Enable 5-6
Beep After Good Decode 38h Enable 5-6
Suppress Power Up Beeps F1h D1h Do Not Suppress 5-7
Beeper Tone 91h Medium 5-8
Beeper Volume 8Ch High 5-9
Beeper Duration F1 74h Medium 5-10
Beep on Insertion F0h 20h Enabled 5-10
Batch Mode F1h 20h Normal (Do Not Batch
Data) 5-11
Hand-Held Trigger Mode 8Ah Level 5-13
Hands-Free Mode F1h 76h Enable 5-14
Presentation Performance Mode F1h 8Ah Standard 5-15