1 - 2
SE4710 Integration Guide
SE4710
The SE4710 contains:
•
a monochrome CMOS image sensor, and
its imaging lens
•
an LED based aiming system
•
an LED based illumination system
•
a software selectable MIPI or parallel interface port, and bi-directional control interface (I
2
C).
provides a block diagram of the imager system.
Figure 1-1
SE4710 Block Diagram
A 27-pin ZIF connector on the SE4710 allows connection of the engine and the host device via a 3.52 in (89.4mm)
flex strip.
The flex is available from Motorola. For information about this connector, see
An LED and associated optics generate an aiming pattern, and a single, high output LED provide illumination for
the imager under virtually any lighting condition. The aiming subsystem, illumination system, and frame rate are
under dynamic software control.
The primary component of the SE4710 imager is a 1/4 in. format CMOS 1280 H x 800 V monochrome digital image
sensor. The CMOS sensor converts photons to a digital representation (8 bits per pixel) of the image present on
the sensor.
NOTE
Both interfaces exist in a single configuration. The user must select the desired interface with the proper
flex and software command.
Summary of Contents for SE4710
