REPEATER
INST
ALL
A
TI
ON
25
Installation Guide
The repeater comes from the factory with the wall
mount attached to the repeater. Detach it by
pushing out the bottom tab as shown in Figure 14b
below:
To install the wall mount:
1.
The wall mount holster is designed to be
capable of mounting to a wall or any other
similar flat surface via screws, straps or
single bolt. (If you choose to use screws,
make sure you secure them tightly on each
one of the wall mount corners).
2.
Once the wall mount is firmly secured to a
surface, slide the repeater device from top to
bottom of the holster (“Figure 14c. Installing
the Wall Mount Holster” on page 26) until the
repeater clicks in place into the wall mount
rails.
3.
Proceed to connect antenna and power
supply cables.
Figure 14b. Detaching the Wall Mount from the
Repeater
Pull tab on the
bottom of the
repeater and slide
down the
holster
Wall mount
bottom tab
Remember not to install the repeater on
or near conductive or shielding
surfaces.
Important
2000018_B_PORS_en.book Page 25 Thursday, January 14, 2010 2:10 PM
