7
Getting started
Connecting the base
1. Plug the telephone line cord into the socket marked
on the underside of the base.
2. Plug the mains power adaptor into the socket marked
on the underside of the base
and plug the other end into the mains power wall socket. The green Power/In use light
comes on and you will hear a confirmation tone.
Installing and charging the handset
1. Make sure the battery ribbon is laying flat inside the battery compartment and insert
the 2 x AAA rechargeable Ni-MH battery cells supplied. Please note the ’+’ and ’-’
markings inside the battery compartment and insert in the correct direction.
2. Replace the battery cover: hook the two plastic clips into place first, then lower and
screw the cover into place. Finally, screw the belt clip on. You can use a coin, e.g. 10c
piece if you don’t have a screwdriver.
3. If you are charging the batteries for the first time, place the handset on the base to
charge for at least 24 hours continuously.
4. When the handset is fully charged,
icon will appear steady on the display. Plug the
other end of the telephone line cord (make sure that one end is already plugged into
the base) into the telephone wall socket.
NOTE
This unit adapts Induction Charging, as such there will be no metal contacts on the
handset or charging cradle.
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for all the
handsets and chargers.
1. Plug the charger power adaptor into the socket marked
on the underside of the
charger and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2 x AAA NiMH
rechargeable batteries supplied. Please note the ’+’ and ’-’ markings inside the battery
